0.6mm CM Ultra-Thin Ultra-Short Large Head Micro Screws
The 0.6mm Ultra-Thin Ultra-Short Large Head Micro Screw is designed for assemblies where the available height and material thickness are both at their limit. The head measures 0.6mm thick but has a large diameter, which increases the contact area against the part being clamped.
That larger contact area is a functional decision, not a cosmetic one. When a small fastener is tightened into a thin plastic or sheet component, the head can sink into the material and pull through, ruining the joint. A wider head spreads the clamping load and prevents that failure mode, keeping thin parts securely held.
The shank is processed to an ultra-short length while remaining fully threaded, so the screw engages reliably in shallow bosses without bottoming out. A precision Phillips drive transfers driving torque consistently, and the installed result stays flat — which is essential in stacked, micro-scale assemblies where a protruding head would interfere with neighbouring components.
Widely used in foldable smartphones, wearable devices, precision sensors and ultra-thin electronic modules, these micro screws suit scenarios with extremely compact internal structures that require both positioning and fastening of slim components.
They are a natural fit for camera modules, hinge assemblies and battery covers, where a fastener must hold firmly without adding height or damaging thin material.
