Bonding Studs — Torx Multi-Tooth Base
This bonding stud builds on the adhesive-bonded concept with a distinctive Torx multi-tooth base. The toothed geometry spreads the adhesive over a far larger contact area than a flat base and, once cured, interlocks mechanically with the bond line, so loads are shared between chemical adhesion and physical engagement. A high-strength threaded pin rises from the base, and tight control of base flatness keeps the stud square to the surface for predictable torque transfer.
The combined effect is high torsional and pull-out strength on materials — carbon-fiber vehicle bodies, glass curtain walls, medical housings — where drilling or riveting would crack or delaminate the substrate. Like all bonding studs, it installs non-destructively, protecting the part while giving a dependable, reusable anchor that meets the demands of extreme operating conditions.
Sharing load between adhesion and tooth engagement, it gives brittle-composite parts a strong anchor that drilling or riveting would destroy in service.
Applied to carbon-fiber vehicle bodies, high-end medical device housings, aerospace composite interiors and precision glass curtain walls, these studs suit brittle or high-hardness composites where traditional drilling and riveting are unfeasible. They meet modern manufacturing demands for weight reduction, non-destructive assembly and stable connections under extreme conditions.
From carbon-fiber bodies and medical housings to aerospace interiors and glass walls, it anchors brittle materials that cannot be drilled.
